pm4-series ? p6mg-xxxxelf ? single output ? dip14 ? 3kv - plastic case specification can change without a notice ? we acce pt no liability for any inaccuracy or printing erro rs. page 1/3 p6mg-xxxxelf all specifications typical at ta=25c, nominal inpu t voltage and full load unless otherwise specified input specifications voltage range 10% input filter capacitors input reflected ripple current1 20 ma pk-pk output specifications voltage accuracy 2% short circuit protection short term line regulation 0.5% load regulation (0% - 100%) 0.5% (3.3vout models: 1.0%) ripple and noise (20mhz bandwidth) 50 mv pk-pk temperature coefficient 0.02% / c general specifications efficiency see table i/o isolation voltage (3 sec.) 3000 vdc i/o isolation capacity 60 pf, typ. i/o isolation resistance 1000 mohm switching frequency 50 khz (variable) humidity 95% rel h reliability calculated mtbf (mil-hdbk-217f) > 4.261 mhrs physical specifications case material non conductive black plastic (ul94v-0 rated) potting material epoxy (ul94v-0 rated) weight ~ 2.7g, typ. environment specifications operating temperature -40 to +85c (ambient) maximum case temperature 100c storage temperature -40 to +125c cooling free air convection rohs conform soldering 260c, max. (1.5mm from case 10s.) mainzer stra?e 151?153 d-55299 nackenheim tel. +49 6135 7026-0 fax: +49 6135 931070 www.peak-electronics.de peak@peak-electronics.de the pm 4 series p6mg - xxxxelf is a family of cost effective 1 w regulated single output dc/dc converters. these converters ar e in an ultra miniature dip14 case. devices are encapsulated. high performa nce features: regulated output, 3000vdc input/output isolation, h igh efficiency operation, output voltage accuracy of 2% maximum, input range of 10% tolerance and low output ripple and noise. pm4-series 1 watt regulated single output dip14 case 3 kv dc i/o isolation low ripple and noise rev.11-2008
pm4-series ? p6mg-xxxxelf ? single output ? dip14 ? 3kv - plastic case specification can change without a notice ? we acce pt no liability for any inaccuracy or printing erro rs. page 2/3 selection guide single output order # i n p u t v o l t a g e ( v d c ) i n p u t c u r r e n t n o l o a d ( m a ) i n p u t c u r r e n t f u l l l o a d ( m a ) o u t p u t v o l t a g e ( v d c ) o u t p u t c u r r e n t f u l l l o a d ( m a ) e f f i c i e n c y ( % ) c a p a c i t o r l o a d ( u f ) 2 single output p6mg-053r3elf 5 30 350 3.3 333 57 220 P6MG-0505ELF 5 35 317 5 200 63 220 p6mg-057r2elf 5 45 327 7.2 138.9 61 220 p6mg-0509elf 5 40 298 9 111.1 67 220 p6mg-0512elf 5 35 298 12 83.3 67 220 p6mg-0515elf 5 35 298 15 66.7 67 220 p6mg-123r3elf 12 20 146 3.3 333 57 220 p6mg-1205elf 12 20 132 5 200 63 220 p6mg-127r2elf 12 20 132 7.2 138.9 63 220 p6mg-1209elf 12 20 128 9 111.1 65 220 p6mg-1212elf 12 20 122 12 83.3 68 220 p6mg-1215elf 12 20 126 15 66.7 66 220 p6mg-243r3elf 24 10 73 3.3 333 57 220 p6mg-2405elf 24 10 76 5 200 60 220 p6mg-247r2elf 24 10 76 7.2 138.9 60 220 p6mg-2409elf 24 10 61 9 111.1 68 220 p6mg-2412elf 24 10 63 12 83.3 66 220 p6mg-2415elf 24 10 63 15 66.7 66 220 if you need other specifications, please enquire. notes:
pm4-series ? p6mg-xxxxelf ? single output ? dip14 ? 3kv - plastic case specification can change without a notice ? we acce pt no liability for any inaccuracy or printing erro rs. page 3/3 package / pinning / derating 7.62 (0.30) 10.16 (0.40) 0.25 (0.01) # single (3kv) 1 - vin 7 n.c. 8 +vout 9 omitted 10 - vout 11 omitted 14 +vin others omitted pin connections app notes: 1 = measured input reflected ripple current with a simu lated source inductance of 12uh. 2 = tested by minimal vin and constant resistive load. - operation under no-load conditions will not damag e these devices, but they will not observe the list ed specifications.
|